During the use of the interlock brick machine, there will always be some large or small failures, which will affect the production and extend the working time, and will delay the production. Therefore, the hollow brick machine should be regularly maintained and overhauled at ordinary times to eliminate minor faults and facilitate the smooth development of production.
1. When installing or replacing new and old molds, be sure to avoid collisions, bumps, civilized assembly, and pay attention to protect the molds;
2. The brick machine often checks the size of the mold and the condition of the welded joints during use. If there is a crack in the weld, it should be repaired in time. If the wear is too fast, the particle size of the aggregate should be adjusted. If the wear is excessive, the quality of the product needs to be equipped with a new mold;
3. Carefully adjust the gap, including the distance between the indenter and the mold core, the indenter and the moving plane of the feed car, the mold frame and the wire plate, and the relative movement must not interfere and rub;
4. When daily cleaning the mold of the interlock brick machine, use an air compressor and soft tools to remove the concrete residue. It is strictly forbidden to gravity beat or pry the mold;
5. The replaced mold should be cleaned and oiled to prevent rust. The supporting pad should be placed in a dry and flat place to prevent gravity deformation. Installation and commissioning of the brick-free machine: Interlock brick machines have been tested in the factory according to relevant regulations, but due to long-distance transportation and long-term storage.
