Maintenance measures for the autoclave of complete equipment for autoclaved lime-sand bricks:
The autoclave must be used in the production of autoclaved bricks in the complete set of equipment for autoclaved lime-sand bricks. We know that the price of the autoclave is very expensive, and the cheap ones cost hundreds of thousands of dollars, so we must do a good job in the daily operation of the autoclave. Maintenance measures, after all, if there is a problem with the autoclave, you will definitely not be able to repair it yourself. You need to find a manufacturer for repairs, and the maintenance cost is not low. Here are the maintenance measures for the autoclave:
1. Check whether the foundation screws of the autoclave bottom of the autoclaved lime-sand brick complete set of equipment are loose, whether there is any abnormality in the foundation or whether there is peeling off of the cement surface of the foundation pier.
2. Clean up the sundries at the bottom of the foundation, so that the bearing shaft can move relative to the kettle body rollers, and the rollers can move freely.
3. Check whether the indicators of the electric control cabinet of the autoclaved lime-sand brick complete set of equipment are normal, especially the safety protection device control system. Drain all the condensed water in the kettle.
4. After the product enters the kettle, close the kettle door and start the safety chain protection device control system. After the indicator light is on and the safety protection pin is inserted into the protection hole, the steam can be slowly filled.
5. According to the time of entering and exhausting the kettle, the kettle that needs to be degassed and paired should be degassed according to the degassing operation procedure.
6. During the production of complete sets of equipment for autoclaved lime-sand bricks, according to the process requirements, the steam pressure should not be higher than 0.95MPa. When filling the steam, you should monitor the reading of the pressure gauge and whether the pressure gauge is normal. Overheating and overpressure are strictly prohibited.
7. When the product reaches the autoclave time and needs to be released from the kettle, open the steam release valve to reduce the pressure to 0 pressure, and the safety indicator light is on before slowly opening the kettle door.
8. The pressure gauge is washed once every shift, and sent for inspection every six months. The safety valve shall be tested for steam exhaust once every shift, and shall be sent for inspection once a year. the
Prev: Automatic brick press is a good helper for construction waste
Next: What should a cost-effective hydraulic brick machine have?
