How to debug the gray sand brick making machine:
Although the lime sand brick making machine has been debugged before leaving the factory, some minor problems may occur during transportation, so when it arrives at the customer's factory area, it also needs to be debugged and tested. When testing the machine, you must pay attention to observation. Observe the degree of depression of the shock absorber. The degree of depression is preferably about 2-3mm. If it is too large, it is easy to cause damage to the equipment. When necessary, you need to adjust the down pressure valve counterclockwise. If the down pressure of the shock absorber is too small, it is best to adjust the down pressure valve clockwise until it is adjusted to the most suitable position. After the debugging is qualified , and then level the feeding hopper with the die. After the debugging is qualified, lock the screws of each part, and then check whether the material on the lower die is scraped clean. This is for the debugging of the shock absorber. In general, it is a relatively complicated debugging method for novices. The lime sand brick making machine manufacturer will send technicians to debug and test the machine, so customers do not need to worry.
In the process of debugging, if the bricks have been produced, if the vibrating force of the vibrator is found to be insufficient, it is best to check whether the pressure of the pressure head cylinder on the lime sand brick making machine is too high. It is best to adjust the pressure relief valve of the upper pipeline of the oil cylinder counterclockwise. If the debugging still has no effect, it has to be debugged until the strength of the brick is produced. Usually it is because the pressure of the upper pressure head is too low, which will lead to inaccurate positioning of the bricks, and inaccurate positioning will lead to loose brick surfaces. At this time, it is necessary to adjust the pressure relief valve of the upper pipeline of the cylinder clockwise. When you lift the lower die of the mold, you can also gently move the wrench of the punch at the same time. These parts are some indispensable parts in the lime sand brick making machine. The purpose of moving the wrench is to maintain a certain pressure on the pressure head cylinder, and at the same time, it can also keep the bricks in the die from rising together with the mold. The advantage is that it can reduce the breakage rate of the bricks.
In the debugging process of the lime sand brick making machine, not only the shock absorber needs to be debugged, but also the concave and convex molds need to be debugged accordingly. During the debugging process, the pressure relationship of each component needs to be paid attention to.
Prev: Porous brick machine automatic production line saves labor, one machine with multiple functions
Next: Brief Introduction of Jaw Crusher for Lime Sand Brick Machine
